#WINISO 5.3 DOES NOT WORKING HOW TO#

Hard disks can refuse service after a while. Exact steps can be found in the manual: setting up a new HDD. You do this via disk management (Windows button + R and search diskmgmt.msc ). Has the installed hard disk been purchased new or has it already been used? If you have purchased a brand new hard drive, you must first install it before Windows can read it. When these steps are completed and all are in order, the housing is in order and we have to focus on the hard drive itself. Check whether the PC / laptop recognizes the USB port Check whether cables and hard disk are properly inserted If the files on your hard disk are not automatically visible, we advise you to check the following points

#WINISO 5.3 DOES NOT WORKING HOW TO#

If you need help with placing the hard disk in the case, please read the How To on orico.shop/kennisbank. We supply this standard, also connect it. When using a 3.5 inch SATA hard disk, an additional power supply must be present. However, if you encounter problems, we will help you on the page to determine the cause and look for a solution.ДЇirst of all, place your SATA hard drive in the housing and connect it with the supplied USB cable. (a few exceptions where hard disks can be attached with a screw connection). Orico products are designed in such a way that in most cases it is a matter of plug & play. My hard drive is not read by the housing, how is this possible?

Winiso 5.3 does not working